/lib/modules/5.4.0-48-generic/kernel/drivers/media/rc/keymaps/rc-rc6-mce.ko.In 18.x the following files are found to be referenced as being on the system for rc6 kernel objects./usr/lib/modules/5.4.0-51-generic/kernel/drivers/media/rc/keymaps/rc-rc6-mce.ko./usr/lib/modules/5.4.0-48-generic/kernel/drivers/media/rc/keymaps/rc-rc6-mce.ko.In 20.x the following files are found to be referenced as being on the system for rc6 kernel objects.(Saw my KEY_ENTER showing up as default of KEY_OK when running ir-keytable -t and pressing buttons) In 20.x it's not preserving some of the entries between reboots.NOTE This section is bound to change a bit: So much for several years of the remote working fully.
#EHOME INFRARED RECEIVER SERVICE UPDATE#
The latest update to the kernel along with probably input lib has killed it in 18.04.x. only works on 18.x with Kodi 17.6 and not Kodi 18.6 (or 18.8 via the stable PPA) in Kubuntu 20.x. and I've tried swapping them just to be sure. Same specs on IR/Remote for both machines.
So you could add 18.x to the wiki page however any help would be seriously appreciated for 20.x of Kubuntu (or Ubuntu 20.x itself as that's the back-end of Kubuntu).īoth systems are current atm however I'm looking to upgrade the older Kubuntu without losing the remote. doing sudo apt-get remove *lirc* can be pretty nasty in either one of these distro's as it would remove Kodi and a few other binaries including vlc. eHome Infrared Remote Transceiver (1784:0001) Driver: mceusb Default keymap: rc-rc6-mce Input device: /dev/input/event8 LIRC device: /dev/lirc0 Attached BPF protocols: Operation not supported Supported kernel protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp imon rc-mm Enabled kernel protocols: lirc rc-6 bus: 3, vendor/product: 1784:0001, version: 0x0000 Repeat delay = 500 ms, repeat period = 125 msītw. $ sudo ir-keytable Found /sys/class/rc/rc0/ with: Name: Media Center Ed.